GM016 REPEAT START TIMER

The GM016 REPEAT START TIMER is a low cost printed circuit board (PCB) assembly designed for panel mounting in ‘prime mover’ applications. On application of a supply voltage, an internal relay energizes for a preset cranking time. Should the engine fail to start, the timer pauses for an equal period then provides a further cranking signal. If after three attempts at starting. The engine still fails to come up to speed, a failed to start relay is energized, and no further cranking can be made until the unit is reset by breaking the supply voltage. The unit must be re-energized when the engine comes up to speed.

Qty:
Categories: ,

INTRODUCTION

The GM016 REPEAT START TIMER is a low cost printed circuit board (PCB) assembly designed for panel mounting in ‘prime mover’ applications. On application of a supply voltage, an internal relay energizes for a preset cranking time. Should the engine fail to start, the timer pauses for an equal period then provides a further cranking signal. If after three attempts at starting. The engine still fails to come up to speed, a failed to start relay is energized, and no further cranking can be made until the unit is reset by breaking the supply voltage. The unit must be re-energized when the engine comes up to speed.

NOTE: The GM016 is one of a range of low cost PCB assemblies designed for OEMs to assemble their own control cubicles for use with automatic standby diesel generator sets and fire pumps etc.

GM016 PCB Assembly

Datasheet GM016.pdf

SPECIFICATIONS

Supply voltage: 12 or 24V DC (specify when ordering)
Timer: 4 to 20 seconds
Cycles: 3
On/off ratio: 1 to 1
Relay contacts: 1 isolated N/O contact on crank relay
1 N/O and N/C contact on failed to start relay
Contact rating: 10A resistive crank relay 5A inductive crank relay
5A resistive fail to start 2.5A inductive fail to start

Reviews

There are no reviews yet.

Be the first to review “GM016 REPEAT START TIMER”
X