Product Details (This product is current)
DE006 - Autostart Module
Added:
  Monday, 18 October 2010
Edited:
  Monday, 18 October 2010

Product Ref No: 138
Order No/Series: DE006


Pricing: $650.00 per unit
This is indicative only. Call for current pricing.

get more info
Once Added, Products will be added to the list at the top of the website.
Click the email icon to submit your request(s).

Products by this Supplier
  » DE002/7 - Speed Sensing Rela.. 
  » DE004 - Engine Protection Mo.. 
  » DE006 - Autostart Module 
  » DE008 - Crank Cycle Timer 
  » DE011 - Under/Over Voltage A.. 
  » DE015 - Reverse Power Relay 
  » DE025 - Phase Failure Relay 
  » DE097 - Speed Sensor 
  » View all above...
DE006 - Autostart Module

The Auto start module (DE006) is used to automatically start-up and to bring on-line a standby generator set and then close it down when normal supply is restored.

Upon mains failure the auto-start module recieves a signal from the phase failure relay and energises a relay to begin cranking the engine. Should the engine fail to start after an elapsed preset cranking time, there is a pause equal in duration to the cranking period before another attempt is made. The multi-shot start is adjustable from 1 to 4 cranking periods and should the engine not start on the final attempt a signal from the auto-start can used to power an indicator light indicating start failure.

Once the engine has started the auto-start module senses the alternator voltage and at a preset level energises a relay, switching the main contactors and putting the standby unit online. On mains return the relay drops out, resetting the contactors and removing the load from the generator set. The engine then runs for the pre-set run-on period at no load allowing it to cool down safely to normal operating temperature. Once the run-on period has elapsed the auto start module signals the engine protection module to shut down the engine.
 
This module is not suitable for operation where transient voltage dips resultin voltage at the input terminals falling below 10 volts for 12V modules or 16 volts for 24 V modules. These transient dips are usually severe when a common battery supply is used for both the control logic circuits and the prime mover cranking motor. Sperate control batteries are recommended.
 
RELATED EQUIPMENT: The phase failure relay is used in conjunction with the auto start module DE006 and engine protection module DE004 to provide a complete auto start system.

SPECIFICATIONS

Supply voltage: 12 or 24V DC
Cranking time: Adjustable 5-25 seconds separated by an equal amount of time
Run on time: Adjustable 2-10 minutes
Dimensions(approximate): 215mm(L) x 135mm(W) x 67mm(H)
Weight(approximate): 0.6kg (600grams)
Finish: Grey hammer tone stoved enamel
PRICE: $650.00
request info

It's 3:08 AM in South Australia.
Please contact us via email.
The DE 011 is a single phase voltage sensing alarm with built in time delays. The time .....
The GM016 REPEAT START TIMER is a low cost printed circuit board (PCB) assembly designed for panel .....
The GM-010 S.C.O. SPEED SWITCH is a panel mounted printed circuit board (PCB) assembly intended primarily for .....
The Crank Cycle timer (DE008) is a small unit, housed in an impact resistant polystyrene case, intended .....